General Electric / GE IS220PDOAH1A Discrete IO Pack Best Price Guaranteed

About the IS220PDOAH1A

 

Characterized as a Discrete Output Pack the IS220PDOAH1A model was designed with interfacing up to two I/O Ethernet networks and other discrete output terminal boards in mind. One special function of this model is that it can control up to twelve relays as well as accept feedback signals from other terminal boards. The typical relays that can be used with this model are solid-state relays and electromagnetic relays. The solid-state relays are used with the TRLYH1B, C, D, and F terminals whereas the electromagnetic relays are used with the TRLYH1E boards. The inputs that will be received on this pack with come through the double RJ45 Ethernet connectors as well as a three-pin power input.

IS220PDOAH1A is a Proportional Digital Output Module Manufactured and designed by General Electric as part of the Mark VIe Series used in GE Distributed Gas Turbine Control Systems. The PDOA provides the electrical interface between one or two I/O Ethernet networks and a discrete output terminal board. The pack contains a processor board common to all Mark VIe distributed I/O packs and an acquisition board specific to the discrete output function. The pack can control up to 12 relays and accepts terminal board-specific feedback. Electromagnetic relays (with types TRLYH1B, C, D, and F terminal boards) and solid-state relays (with type TRLYH1E boards) are available. Input to the pack is through dual RJ45 Ethernet connectors and a three-pin power input. Output is through a DC-37 pin connector directly with the associated terminal board connector. Visual diagnostics are provided through indicator LEDs, and local diagnostic serial communications are possible through an infrared port.

Directly plug one PDOA I/O pack for simplex or three PDOA I/O packs for TMR into the terminal board connectors.

Mechanically secure the packs using the threaded studs adjacent to the Ethernet ports. The studs slide into a mounting bracket specific to the terminal board type. The bracket location should be adjusted such that there is no right-angle force applied to the DC37 connector between the pack and the terminal board. The adjustment should only be required once in the life of the product.

Plug in one or two Ethernet cables depending on the system configuration. The pack will operate over either port. If dual connections are used, the standard practice is to connect ENET1 to the network associated with the R controller.

Apply power to the pack by plugging in the connector on the side of the pack. It is not necessary to insert this connector with the power removed from the cable as the I/O pack has inherent soft-start capability that controls the current inrush on the power application.

Is General Electric IS220PDOAH1A not the part you are wanting?

Check out the rest of our website to see what else we have to offer!

✉ sales7@apterpower.com     ☏ +8618030175807

key words: is220pdoah1a;GE IS220PDOAH1A;IS220PDOAH1A pdf;IS220PDOAH1A datasheet;IS220PDOAH1A manual;IS220PDOAH1A new